Update README.md
diff --git a/README.md b/README.md
index 6f0ae63..ef76673 100644
--- a/README.md
+++ b/README.md
@@ -7,6 +7,81 @@
## LDO Design
This is a caravel that has an LDO Design implemented on Skywaters 130nm technology.
+
+
+# LDO Simulation
+
+We have an enable switch so all the following analysis when the enable signal is high.
+
+## Schematic
+
+
+
+## Error Amplifier
+
+
+
+## Bandgap
+
+
+
+
+## a. DC analysis
+
+We used dc analysis for displaying the operating point for proper biasing of transistors and also dc sweep of output voltage against variations in supply and temprature to calculate dropout voltage,line regulation,temperature coefficient.
+
+## Supply variation
+We made dc sweep on the supply and plotted voltage of the output node and vdd node overlaid on the same plot
+
+
+
+## Temperature variation
+We made dc sweep on temperature from 0 to 85°C and plotted the output voltage vs temperature from which we found temperature coeffiecient in ppm/°C.
+
+
+
+## c. AC analysis
+## PSRR
+We used AC analysis by injecting small ac signal over the supply and plotted the output voltage in dB which refers to the PSRR vs Frequency.
+
+
+## Stability analysis
+We made the above testbench to cut the feedback loop of the ldo and inject ac signal and then measure the loop gain and phase to find phase margin.
+## d. Transient analysis
+
+## Line Transient
+We used transient analysis to show the line transient by varying the supply from 0 to vdd at different supply levels corners such that the nominal supply is 2.3v.
+When VDD varies from 0 to 2.3v
+
+When VDD varies from 0 to 2.07v
+
+When VDD varies from 0 to 2.53v
+
+## Load Transient
+The load is varied from 0.1mA to 10mA where the load is modeled as current source varied as PWL source.
+
+## e. Testbench netlist
+
+The netlist of all previous analyses is below or you can simply run it using script "LDO_script.bash" existed in scripts folder.
+
+
+
+## Simulation results
+The typical conditions are tt corner ,load of 50uA, T=27°C , VDD=2.3V , We have a script to automate running process corners then getting their statistical distribution where the variation of the load from 50uA till 100mA is included in the corners
+
+ Specification | TT
+-----------------| ---------------
+Temperature Coeffiecient | 49.4 ppm/°C
+Dropout Voltage | 0.124mV
+Line Regulation | 0.0325 mv/v
+Load Regulation | 0.06mV IL=0.1mA till IL=10mA
+PSRR @ 100Hz | 88.1dB
+PSRR @ 100kHz | 44.7dB
+Load range | 50uA -> 100mA
+Phase Margin | 50.1°
+Quiescent Current | 130uA
+
+
### Circuit Design
The implementation of the LDO is as follows.
