| commit | 229830ec6a4973c1573da3600f61e2112d75acee | [log] [tgz] |
|---|---|---|
| author | Jeff DiCorpo <jeffdi@efabless.com> | Sun Jan 09 08:53:26 2022 -0800 |
| committer | Jeff DiCorpo <jeffdi@efabless.com> | Sun Jan 09 08:53:26 2022 -0800 |
| tree | 550954d972ab1157e9ecd6af5ba70d697944c594 | |
| parent | a7302ccf8bd2727b6b3e08dbb2cca5f99eb3ff38 [diff] |
final gds oasis
Turbo Encoder is used for FEC encoding for linear modulation.
Encoder takes 2 bits of input (namely A and B) and generates 6 bits of output in the form (AB Y1W1 Y2W2)
First couple of parity bits (Y1W1) are generated from linearly ordered input data while second couple of parity bits (Y2W2) are generated from interleaved input data.
The design involves two paths:
-Input Data is stored at dual channel rams.
-AGU's (Address Generator Unit) generate data indices for linearly ordered and interleaved data inputs.
-Pre Encoder unit identifies initial state of the encoder.
-Encoder Core produces outputs according to the state and the inputs.
-Reports are based on Xilinx Spartan-7 xc7s6ftgb196-1
‘N’ = input data block size in couple number ranging from 56 to 2396.
‘f’ = frequency in Mhz.
For 50 Mhz clock speed and N = 56, throughput equals to 31.5 Mbps.
For 50 Mhz clock speed and N = 2396, throughput equals to 33.3 Mbps.
To setup caravel, run the following
git clone https://github.com/yongatek/caravel_yonga-turbo-encoder.git cd caravel_yonga-turbo-encoder make install
Setup the pdk
export PDK_ROOT=<pdk-installation-path> make pdk
First, you will need to install the simulation environment, by
make simenv
Then set the environment properly
export PDK_ROOT=<pdk-installation-path> export CARAVEL_ROOT=$(pwd)/caravel
Specify simulation mode
export SIM=RTL # use the command below for GL simulation # export SIM=GL
Run these commands to test YONGA-Turbo Encoder
# run Turbo Encoder WB test make verify-turbo_encoder_wb_test # run Turbo Encoder GPIO test make verify-turbo_encoder_gpio_test
First, you will need to install openlane to harden the user project macro
export OPENLANE_ROOT=<openlane-installation-path> make openlane
To harden the user project macro run the following
# Run openlane to harden user_proj_example make user_proj_example # Run openlane to harden user_project_wrapper make user_project_wrapper
In alphabetical order:
