| // SPDX-FileCopyrightText: 2020 Efabless Corporation | |
| // | |
| // Licensed under the Apache License, Version 2.0 (the "License"); | |
| // you may not use this file except in compliance with the License. | |
| // You may obtain a copy of the License at | |
| // | |
| // http://www.apache.org/licenses/LICENSE-2.0 | |
| // | |
| // Unless required by applicable law or agreed to in writing, software | |
| // distributed under the License is distributed on an "AS IS" BASIS, | |
| // WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. | |
| // See the License for the specific language governing permissions and | |
| // limitations under the License. | |
| // SPDX-License-Identifier: Apache-2.0 | |
| `default_nettype none | |
| // Digital PLL (ring oscillator + controller) | |
| // Technically this is a frequency locked loop, not a phase locked loop. | |
| `include "digital_pll_controller.v" | |
| `include "ring_osc2x13.v" | |
| module digital_pll( | |
| `ifdef USE_POWER_PINS | |
| VPWR, | |
| VGND, | |
| `endif | |
| resetb, enable, osc, clockp, div, dco, ext_trim); | |
| `ifdef USE_POWER_PINS | |
| input VPWR; | |
| input VGND; | |
| `endif | |
| input resetb; // Sense negative reset | |
| input enable; // Enable PLL | |
| input osc; // Input oscillator to match | |
| input [4:0] div; // PLL feedback division ratio | |
| input dco; // Run in DCO mode | |
| input [25:0] ext_trim; // External trim for DCO mode | |
| output [1:0] clockp; // Two 90 degree clock phases | |
| wire [25:0] itrim; // Internally generated trim bits | |
| wire [25:0] otrim; // Trim bits applied to the ring oscillator | |
| wire creset; // Controller reset | |
| wire ireset; // Internal reset (external reset OR disable) | |
| assign ireset = ~resetb | ~enable; | |
| // In DCO mode: Hold controller in reset and apply external trim value | |
| assign itrim = (dco == 1'b0) ? otrim : ext_trim; | |
| assign creset = (dco == 1'b0) ? ireset : 1'b1; | |
| ring_osc2x13 ringosc ( | |
| .reset(ireset), | |
| .trim(itrim), | |
| .clockp(clockp) | |
| ); | |
| digital_pll_controller pll_control ( | |
| .reset(creset), | |
| .clock(clockp[0]), | |
| .osc(osc), | |
| .div(div), | |
| .trim(otrim) | |
| ); | |
| endmodule | |
| `default_nettype wire |