| // SPDX-FileCopyrightText: 2020 Efabless Corporation | |
| // | |
| // Licensed under the Apache License, Version 2.0 (the "License"); | |
| // you may not use this file except in compliance with the License. | |
| // You may obtain a copy of the License at | |
| // | |
| // http://www.apache.org/licenses/LICENSE-2.0 | |
| // | |
| // Unless required by applicable law or agreed to in writing, software | |
| // distributed under the License is distributed on an "AS IS" BASIS, | |
| // WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. | |
| // See the License for the specific language governing permissions and | |
| // limitations under the License. | |
| // SPDX-License-Identifier: Apache-2.0 | |
| `default_nettype none | |
| /* Convert the standard set of GPIO signals: input, output, output_enb, | |
| * pullup, and pulldown into the set needed by the s8 GPIO pads: | |
| * input, output, output_enb, input_enb, mode. Note that dm[2] on | |
| * thepads is always equal to dm[1] in this setup, so mode is shown as | |
| * only a 2-bit signal. | |
| * | |
| * This module is bit-sliced. Instantiate once for each GPIO pad. | |
| * (Caravel has only one GPIO pad, so bit-slicing is irrelevant.) | |
| */ | |
| module convert_gpio_sigs ( | |
| input gpio_out, | |
| input gpio_outenb, | |
| input gpio_pu, | |
| input gpio_pd, | |
| output gpio_out_pad, | |
| output gpio_outenb_pad, | |
| output gpio_inenb_pad, | |
| output gpio_mode1_pad, | |
| output gpio_mode0_pad | |
| ); | |
| assign gpio_out_pad = (gpio_pu == 1'b0 && gpio_pd == 1'b0) ? gpio_out : | |
| (gpio_pu == 1'b1) ? 1 : 0; | |
| assign gpio_outenb_pad = (gpio_outenb == 1'b0) ? 0 : | |
| (gpio_pu == 1'b1 || gpio_pd == 1'b1) ? 0 : 1; | |
| assign gpio_inenb_pad = ~gpio_outenb; | |
| assign gpio_mode1_pad = ~gpio_outenb_pad; | |
| assign gpio_mode0_pad = gpio_outenb; | |
| endmodule | |
| `default_nettype wire |