Google Git
Sign in
foss-eda-tools / third_party / shuttle / sky130 / mpw-008 / slot-034 / aa2814a577ce95062e33b02c9908628c881728cf
commitaa2814a577ce95062e33b02c9908628c881728cf[log] [tgz]
authorm-usama-z <107983847+m-usama-z@users.noreply.github.com>Sat Nov 26 14:54:55 2022 +0500
committerGitHub <noreply@github.com>Sat Nov 26 14:54:55 2022 +0500
tree9742fa8e068fb34c195713f0b6ff10c646e1ac99
parent2e3044567c2ef512bbb32fc3f89aefbeaccb7478 [diff]
Update README.md
1 file changed
tree: 9742fa8e068fb34c195713f0b6ff10c646e1ac99
  1. .github/
  2. def/
  3. dependencies/
  4. deps/
  5. docs/
  6. gds/
  7. lef/
  8. lib/
  9. mag/
  10. maglef/
  11. openlane/
  12. sdc/
  13. sdf/
  14. signoff/
  15. spef/
  16. spi/
  17. venv/
  18. verilog/
  19. caravel
  20. mgmt_core_wrapper
  21. .gitignore
  22. a.out
  23. LICENSE
  24. Makefile
  25. README.md
  26. README.md.old
README.md

UETRV_ESoC_v2

UETRV_ECORE_v2 is a RISC-V based SoC derived from UETRV_ESoC with a few changes; it has been passed through the Cadence VLSI flow for submission to Google and Efabless' Open-MPW-8 shuttle program using Skywater's open-source 130 nm PDK. The verilog RTL used in this repo is generated from Scala source, available here. Further details about the peripheral memory map, bootloader, example programs, testbenches etc. are also provided in that repo.

Updates from UETRV_ESoC

The following are the differences between UETRV_ESoC_v2 and UETRV_ESoC:

  • Fixed width of address bus in the instruction bus. Previously, the address bus was 2 bits narrower than required for the instruction memory size specified in the config.scala file.
  • Fixed selection of the motor control module to be accessed using the address given to data bus. Previously, although three motor control modules were instantiated, only the first motor module was accessible.
  • Fixed data memory to be word-addressable. Previously, data memory was byte-addressable which did not map properly to the Skywater PDK's SRAMs.
  • Added 2 inputs and 2 outputs to the motor control module, to aid in controlling stepper motors for a plotter's operation. The 2 inputs have been used to read the state of homing switches, and the 2 outputs have been used to provide the direction inputs to the stepper motor driver, but this usage of the IOs been done using firmware, thus they can be easily used for other purposes by modifying the firmware written in C language.
  • Increased instruction memory size to 8 KB and data memory size to 4 KB. As shown in the image below, the 4 lower SRAMs constitute the instruction memory and the 2 upper SRAMs constitute the data memory.