Update docs to add PRBS generator
diff --git a/README.md b/README.md
index 2e0e11b..400fd9b 100644
--- a/README.md
+++ b/README.md
@@ -44,8 +44,9 @@
`tx/rx_pu/pd_cal` signals control the calibration FETs within the legs.
As can be seen in the diagram, there are 3 alternate data inputs. This allows external signals to be substituted for the input signal.
-In this design, `data_0` is tied to VDD, `data_2` is tied to VSS (ground) and `data_3` is connected to `la_data_in[0]`.
-The ability to set the signal output to a static high or low voltage will be helpful when manually performing the calibration procedure in the lab.
+In this design, `data_0` is tied to VDD, `data_2` is tied to a PRBS-31 sequence generator, and `data_3` is connected to `la_data_in[0]`.
+
+The PRBS-31 sequence generator is clocked by a ring-oscilator with a configurable clock divider. There are 8 clock speeds controlled by 3 control bits. Binary 0 is the fastest clock and binary 7 is the slowest. There is also an active low reset signal to reset the PRBS lfsr state to "1".
## Pinout
@@ -60,6 +61,10 @@
| IO[17] | io_analog[3] | Digital VSS (gnd) |
| IO[25] | gpio_analog[7] | configuration data in |
| IO[26] | gpio_analog[8] | configuration clock in |
+| IO[27] | gpio_analog[9] | PRBS clock config bit 0 |
+| IO[28] | gpio_analog[10] | PRBS clock config bit 1 |
+| IO[29] | gpio_analog[11] | PRBS clock config bit 2 |
+| IO[30] | gpio_analog[12] | PRBS state active low reset |
## Chip Configuration Interface
