A custom microcomputer design is useful when off-the-shelf general-purpose microcontrollers fail to meet the system needs. The rocket SoC generator automatically generate an SoC. It circumvents labor-intensive, error-prone, top-level SoC design.
The Rocket SoC Generator and Caravel SoC Template are reused to create a twin (not identical) RISC-V SoC consisting of one Rocket RISC-V and one Caravel RISC-V. The objectives here is to save hours on design verification and reduce power consumption rather than saving die area or chip cost.
graph TD A(A SoC Wish List) -- SoC Description in Chisel--> B B[The Rocket SoC Generator] --SoC RTL--> D[The OpenLane Flow] C[Caravel SoC Harness] --Harness RTL--> D B --FPGA RTL--> L P[RISC-V IDE Tools]--Code and Executables-->H L[_Yosys_+nextpnr] --Bitstream--> K[Lattice ECP5 Eval Board] E(Caravel Firmware) --Init, Monitoring, Debug--> C D --Sky130 GDS II Layout Data--> F[eFabless MPW] O[Xschema]--Circuit schematics-->J F --MPW Chips--> H F --MPW Chips--> I I[Caravel EVB] --Breadboarding-->H{User system} J[KiCad]--Gerber and BOM-->H
The following shows a scheme to manage clock, reset, power and low power state.
sequenceDiagram Note right of System: Powers<br/>Caravel<br/>Chip. System -->> Harness: Reset System -->> Harness: Reset System -->> Caravel SoC: Reset Harness -->> Caravel SoC: core clock Harness -->> Caravel SoC: core reset Caravel SoC->>Harness: Configuration of clk, DLL Caravel SoC->>Harness: Configure pad data routing and GPIO Harness-->>Rocket SoC: Set user_clock full speed Caravel SoC->>Rocket SoC: Reset user logic Note left of Rocket SoC: Rocket boots<br/>from ROM logic<br/>XIP SPI flash<br/>runs on DTIM. Rocket SoC -->> Caravel SoC: Rocket is running OK Note left of Caravel SoC: Acknoleging <br/>Rocket OK<br/>tuns off External<br/>CPG power<br/>via GPIO or I2C. Caravel SoC->>System: Turn off External CPG Power Note left of Rocket SoC: Rocket sends message<br/>"Bring Caravel<br/>to lowest power state"<br/>e.g. wishbone mailbox<br/>and interrupt. Rocket SoC->>Caravel SoC: "Go low on power" Note left of Caravel SoC: Management SoC sets<br/>Clocking and DLL<br/> to Caravel's<br/>lowest power state<br/>via System control. Caravel SoC->> Harness: Caravel goes low power. Note left of Rocket SoC: Rocket gets<br/>wake up signal<br/>from RTC. Rocket SoC->>Caravel SoC: "Go full power" Caravel SoC->>Harness: Configure Clock, DLL via System control Caravel SoC->>Rocket SoC: "Went full power".
Unit | Description |
---|---|
RISC-V CPU | RV32IMAC, M/S/U-mode (Rocket) |
I-Cache | Instruction cache: 16 KiB (Up to 8 KiB can be configured as Instruction Tightly Integrated Memory (ITIM)) |
D-Cache | Data cache: 8 KiB |
QSPI0 | Quad Serial Peripheral Interface (QSPI) for (Q)SPI-Flash memory (XIP supported) |
QSPI1 | Quad Serial Peripheral Interface (QSPI) for (Q)SPI-Peripherals (CS x2) |
QSPI2 | Quad Serial Peripheral Interface (QSPI) for (Q)SPI-PSRAM (XIP supported) |
UART0-4 | Universal Asynchronous Receiver/Transmitter (UART) x5 |
I2C0-1 | Inter-Integrated Circuit (I2C) Master Interface x2 |
PWM0-2 | Pulse Width Modulator (PWM) (4x 16-bit comparators/unit) x3 |
Debug | Debug functions, JTAG I/F |
Refer to Freedom E310-G002 Manual for detailed specification of each unit except QSPI2. For QSPI2, refer to docs/SPI_with_PSRAM_Interface.pdf .
mprj_io[#] | Mgmt. SoC | Marmot IOF0 | Marmot IOF1 | Marmot GPIO |
---|---|---|---|---|
0 | JTAG | - | - | - |
1 | SDO | TDO | - | - |
2 | SDI | TDI | - | - |
3 | CSB | TMS | - | - |
4 | SCK | TCK | - | - |
5 | ser_rx | UART0_rx | - | - |
6 | ser_tx | UART0_tx | - | - |
7 | irq | QSPI1_csb[1] | - | GPIO[24] |
8 | flash2_csb | QSPI0_flash_csb | - | - |
9 | flash2_sck | QSPI0_flash_sck | - | - |
10 | flash2_io[0] | QSPI0_flash_io[0] | - | - |
11 | flash2_io[1] | QSPI0_flash_io[1] | - | - |
12 | - | QSPI0_flash_io[2] | - | - |
13 | - | QSPI0_flash_io[3] | - | - |
14 | - | QSPI1_csb[0] | - | GPIO[0] |
15 | - | QSPI1_sck | - | GPIO[1] |
16 | - | QSPI1_io[0] | - | GPIO[2] |
17 | - | QSPI1_io[1] | - | GPIO[3] |
18 | - | QSPI1_io[2] | - | GPIO[4] |
19 | - | QSPI1_io[3] | - | GPIO[5] |
20 | - | QSPI2_csb | - | - |
21 | - | QSPI2_sck | - | - |
22 | - | QSPI2_io[0] | - | - |
23 | - | QSPI2_io[1] | - | - |
24 | - | QSPI2_io[2] | - | - |
25 | - | QSPI2_io[3] | - | - |
26 | - | I2C0_sda | PWM0_0 | GPIO[12] |
27 | - | I2C0_scl | PWM0_1 | GPIO[13] |
28 | - | I2C1_sda | PWM0_2 | GPIO[14] |
29 | - | I2C1_scl | PWM0_3 | GPIO[15] |
30 | - | UART1_rx | PWM1_0 | GPIO[16] |
31 | - | UART1_tx | PWM1_1 | GPIO[17] |
32 | - | UART2_rx | PWM1_2 | GPIO[18] |
33 | - | UART2_tx | PWM1_3 | GPIO[19] |
34 | - | UART3_rx | PWM2_0 | GPIO[20] |
35 | - | UART3_tx | PWM2_1 | GPIO[21] |
36 | - | UART4_rx | PWM2_2 | GPIO[22] |
37 | - | UART4_tx | PWM2_3 | GPIO[23] |
Base | Top | Attribute | Unit | Description |
---|---|---|---|---|
0x0000_0000 | 0x0000_0FFF | RWX A | Debug | Debug Address Space |
0x0000_1000 | 0x0000_2FFF | - | Reserved | - |
0x0000_3000 | 0x0000_3FFF | RWX A | Error Device | Error Address Space |
0x0000_4000 | 0x0000_FFFF | - | Reserved | - |
0x0001_0000 | 0x0001_1FFF | R XC | Boot ROM | Boot ROM (8 KiB) |
0x0001_2000 | 0x0002_1FFF | - | Reserved | - |
0x0200_0000 | 0x0200_FFFF | RW A | CLINT | Core-Local Interruptor |
0x0201_0000 | 0x07FF_FFFF | - | Reserved | - |
0x0800_0000 | 0x0800_1FFF | RWX A | ITIM | Instruction Tightly Integrated Memory (up to 8KiB) |
0x0800_2000 | 0x0BFF_FFFF | - | Reserved | - |
0x0C00_0000 | 0x0FFF_FFFF | RW A | PLIC | Platform-Level Interrupt Controller |
0x1000_0000 | 0x1000_0FFF | RW A | AON | Always-On Domain (WDT, RTC, PMU, etc.) |
0x1000_1000 | 0x1001_1FFF | - | Reserved | - |
0x1001_2000 | 0x1001_2FFF | RW A | GPlO | General Purpose Input/Output Controller |
0x1001_3000 | 0x1001_3FFF | RW A | UART0 | Universal Asynchronous Receiver/ Transmitter #0 |
0x1001_4000 | 0x1001_4FFF | RW A | QSPI0 | Quad Serial Peripheral Interface #0 for (Q)SPI-Flash memory (XIP supported) |
0x1001_5000 | 0x1001_5FFF | RW A | PWM0 | Pulse Width Modulator #0 |
0x1001_6000 | 0x1001_6FFF | RW A | I2C0 | Inter-Integrated Circuit Master Interface #0 |
0x1001_7000 | 0x1002_2FFF | - | Reserved | - |
0x1002_3000 | 0x1002_3FFF | RW A | UART1 | Universal Asynchronous Receiver/ Transmitter #1 |
0x1002_4000 | 0x1002_4FFF | RW A | QSPI1 | Quad Serial Peripheral Interface #1 for (Q)SPI-Peripherals |
0x1002_5000 | 0x1002_5FFF | RW A | PWM1 | Pulse Width Modulator #1 |
0x1002_6000 | 0x1002_6FFF | RW A | I2C1 | Inter-Integrated Circuit Master Interface #1 |
0x1002_7000 | 0x1003_2FFF | - | Reserved | - |
0x1003_3000 | 0x1003_3FFF | RW A | UART2 | Universal Asynchronous Receiver/ Transmitter #2 |
0x1003_4000 | 0x1003_4FFF | RW A | QSPI2 | Quad Serial Peripheral Interface #2 for (Q)SPI-PSRAM (XIP supported) |
0x1003_5000 | 0x1FFF_FFFF | RW A | PWM2 | Pulse Width Modulator #2 |
0x1004_3000 | 0x1005_2FFF | RW A | UART3 | Universal Asynchronous Receiver/ Transmitter #3 |
0x1004_4000 | 0x1005_2FFF | - | Reserved | - |
0x1005_3000 | 0x1005_3FFF | RW A | UART4 | Universal Asynchronous Receiver/ Transmitter #4 |
0x1005_4000 | 0x1FFF_FFFF | - | Reserved | - |
0x2000_0000 | 0x3FFF_FFFF | R XC | (Q)SPI-Flash | Off-Chip (Q)SPI-Flash Memory (up to 512 MiB) |
0x4000_0000 | 0x5FFF_FFFF | RWXC | (Q)SPI-PSRAM | Off-Chip (Q)SPI-PSRAM (up to 512 MiB) |
0x6000_0000 | 0xFFFF_FFFF | - | Reserved | - |
Marmot RISC-V ASIC for Motor Control (Efabless MPW-7 project)
This work is based on results obtained from project, JPNP16007, commissioned by The New Energy and Industrial Technology Development Organization (NEDO).