| 11.0 Analog Devices |
| ==================== |
| These rules MUST BE used in conjunction with 0.18um Baseline rules in section 7. The following sub- |
| sections use the analog terms defined in the table below. |
| |
| .. csv-table:: analogdev |
| :file: tables_clear/11.0_Analogterms_definitions.csv |
| :widths: 400,400 |
| :align: center |
| |
| * "For accurate resistance value control, it is strongly recommended that the resistor width ≥ 2.0um |
| and number of square ≥ 5. If POLY or DIFFUSION resistor width less than minimal Design Rules |
| indicate in below sections, the resistors values may not be accurate. Please refer to Resistor |
| Characterization/Mismatch Report for detailed design. |
| * It is recommended to maximize the number of contacts on the resistor reduce the contact |
| resistance. |
| * It is strongly recommended that the contacts on the resistor were arranged in a single column. |
| |
| .. toctree:: |
| :glob: |
| |
| drm_11_1 |
| drm_11_2 |
| |
