blob: 0b120a187598b1eff0c1a20202625db12b7d4e87 [file] [log] [blame]
5.1 Guidelines for polygon shapes to be avoided
===============================================
This section describes the shapes or the patterns, which shall be avoided for, better manufacturability and yield.
**SH.1**: Avoid any COMP, POLY and metal circular or arch shapes with exception only for pre-tested metal inductors with IND_MK mark layer.
.. image:: images/sh1.png
:width: 600
:align: center
:alt: SH.1
**SH.2**: Avoid any COMP, poly and metal shapes with acute angles (angles <90 deg). Exceptions are only for pre-tested metal inductors with IND_MK mark layers and lettering (non circuit elements).
.. image:: images/sh2.png
:width: 600
:align: center
:alt: SH.2
**SH.3**: Avoid COMP and poly intercepting with one side COMP wider and other side (as shown below)
.. image:: images/sh3.png
:width: 600
:align: center
:alt: SH.3
**SH.4**: Neither COMP nor poly can be tapered within in the intersect area. (Exceptions only for pre-tested SRAM and other memory cells with mark layer).
.. image:: images/sh4.png
:width: 600
:align: center
:alt: SH.4
**SH.5**: Poly bends in active shall be avoided if accuracy of transistor width is important and also in analog blocks. (Exceptions only for pre-tested SRAM and other memory cells with mark layer). This case the accuracy of circuit speed /timing will degraded.
.. image:: images/sh5.png
:width: 600
:align: center
:alt: SH.5
**SH.6**: Following U shape shall be avoided for COMP layer: Especially when X <1.0um and/or Y<0.5um. Exceptions are only for proven memory cells with SRAM bit cell marking layer (Gmcell).
.. image:: images/sh6.png
:width: 600
:align: center
:alt: SH.6
**SH.7**: Following shape of COMP forming transistors shall be avoided in general and more importantly when X and /or Y dimensions are less than 5um. (Exceptions are only for proven memory cells with SRAM bit cell marking layer (Gmcell).
.. image:: images/sh7.png
:width: 600
:align: center
:alt: SH.7
**SH.8**: Contact on COMP in following manner with minimum rules shall be avoided. (Exceptions are only for proven memory cells with SRAM bit cell marking layer (Gmcell).
.. image:: images/sh8.png
:width: 600
:align: center
:alt: SH.8
**SH.9**: Following type-a, type-b and type-c kind of resistor layout shall be avoided: (for matched pair resistors, please refer to matched pair design guidelines in the design rule document).
.. image:: images/sh9.png
:width: 800
:align: center
:alt: SH.9