diff --git a/README.md b/README.md
index 9679858..bae5f64 100644
--- a/README.md
+++ b/README.md
@@ -35,9 +35,11 @@
 
 Then, you will need to put your design aboard the Caravel chip. Make sure you have the following:
 
-- Magic installed on your machine. We may provide a Dockerized version later.
+- [Magic VLSI Layout Tool](http://opencircuitdesign.com/magic/index.html) installed on your machine. We may provide a Dockerized version later.\*
 - You have your user_project_wrapper.gds under `./gds/` in the Caravel directory.
 
+ > \* **Note:** You can avoid the need for the magic prerequisite by using the openlane docker to run the make step. This [section](#running-make-using-openlane's-magic) shows how.
+
 Run the following command:
 
 ```bash
@@ -47,6 +49,32 @@
 
 This should merge the GDSes using magic and you'll end up with your version of `./gds/caravel.gds`. You should expect hundred of thousands of magic DRC violations with the current "development" state of caravel.
 
+## Running Make using OpenLANE's Magic
+
+To use the magic installed inside Openlane to complete the final GDS streaming out step, export the following:
+
+```bash
+export PDK_ROOT=<The location where the pdk is installed>
+export OPENLANE_ROOT=<the absolute path to the openlane directory cloned or to be cloned>
+export IMAGE_NAME=<the openlane image name installed on your machine. Preferably openlane:rc5>
+export CARAVEL_PATH=$(pwd)
+```
+
+Then, mount the docker:
+
+```bash
+docker run -it -v $CARAVEL_PATH:$CARAVEL_PATH -v $OPENLANE_ROOT:/openLANE_flow -v $PDK_ROOT:$PDK_ROOT -e CARAVEL_PATH=$CARAVEL_PATH -e PDK_ROOT=$PDK_ROOT -u $(id -u $USER):$(id -g $USER) $IMAGE_NAME
+```
+
+Finally, once inside the docker run the following commands:
+```bash
+cd $CARAVEL_PATH
+make
+exit
+```
+
+This should merge the GDSes using magic and you'll end up with your version of `./gds/caravel.gds`. You should expect hundred of thousands of magic DRC violations with the current "development" state of caravel.
+
 ## Managment SoC
 The managment SoC runs firmware that can be used to:
 - Configure User Project I/O pads