| ################################################################################## | |
| # POST-PRE_CTS PLUG-IN | |
| ################################################################################## | |
| # | |
| # This plug-in is called after optDesign -preCTS from the run_prects.tcl flow | |
| # script. The user can use this plug-in for: | |
| # | |
| # -------------------------------------------------------------------------------- | |
| # - Secondary power pin routing for low power cells | |
| # - State retention flops | |
| # - Always-on-buffers | |
| # - Level-shifters | |
| # - Check the connectivity and geometry on these nets | |
| # -------------------------------------------------------------------------------- | |
| # Below are some example commands ... | |
| #################################################################################### | |
| #################################################################################### | |
| # Secondary power routing for SRPG/AON/LVL cells using nanoroute ... | |
| # It requires vars(secondary_pg,cell_pin_pairs) to be defined in the lp_config.tcl | |
| # -------------------------------------------------------------------------------- | |
| # NOTE: In the early stage of the flow (before CTS) if user wants to estimate the | |
| # routing resource impact due to secondary pg pin routing, he can do secondary pg pin | |
| # connection before CTS OR if user enables "vars(route_secondary_pg_nets)" as true in | |
| # OVERLAY/lp_config.tcl then same would be done before the routing stage also. | |
| # -------------------------------------------------------------------------------- | |
| ::FF_EDI::route_secondary_pg_nets | |
| #################################################################################### | |
| ## Check for Geometry and connectivity violations on power nets | |
| #################################################################################### | |
| clearDrc | |
| verifyConnectivity \ | |
| -type special \ | |
| -noAntenna \ | |
| -nets { VSSsoc VDDdvfs VDDw VDDsmc VDDuart VDDwake VDDpll } \ | |
| -report $vars(rpt_dir)/$vars(design).conn.rpt | |
| verifyGeometry \ | |
| -allowPadFillerCellsOverlap \ | |
| -allowRoutingBlkgPinOverlap \ | |
| -allowRoutingCellBlkgOverlap \ | |
| -error 1000 \ | |
| -report $vars(rpt_dir)/$vars(design).geom.rpt | |
| clearDrc |